PRIDE was launched and sea trialed here in Brooklin in the summer of 1995 after which she was placed on a trailer and delivered to her (then) owners home on the shore of Lake Ontario. PRIDE sailed there for the rest of that summer before being hauled out for winter storage. For unknown reasons her (then) owners never launched PRIDE again.
In the fall of 2016 Brooklin Boat Yard purchased her and had her brought back to the yard for a significant refit. The refit (done over 2016-2017 winter) included some repair of water damage but mostly was done to renew the cosmetics of the boat (paint and varnish finishes) and replace items that had deteriorated or been ruined due age and exposure (new standing & running rigging, new sails & canvas)
With the refit completed PRIDE is being launched in time for the 2017 Eggemoggin Reach Regatta where she will have the opportunity to stretch her legs and strut her stuff on the race course. After the regatta PRIDE will be on a mooring here at Brooklin Boat Yard available for inspection and test sail for qualified candidates.
Designer: Nathanial G. Herreshoff
Builder: Brooklin Boat Yard
Year Built: 1995
LOA: 32’ 3”
LWL: 25’ 4”
Beam: 8’ 9”
Minimum Draft: 3’ 0”
Maximum Draft: 6’ 0”
Sail Area: 539 sq. ft.
Displacement: 7,386 lbs.
Cold-molded, wood-epoxy construction using WEST Systems epoxies for adhesion and coatings
Hull laminate schedule as follows (interior to exterior)
1) Longitudinal ¾” White cedar strip planking
2) 1/8” Meranti veneer at 45 degrees
3) 1/8” Meranti veneer at 135 degrees
Decks and cabin top are marine plywood over-laid with Dynel cloth set in epoxy
House sides, aft house bulkhead, cabin doors, companionway hatch slide, toe rails, cockpit coamings & deck trim are of varnished mahogany
Cast bronze chocks & Spartan Marine “Correct Cleat” bronze docking cleats
Bronze dorade-type vent in forepeak
Cockpit seats, cockpit sole and (interior) cabin soles are of bare, unfinished teak.
Topsides painted white.
Decks and cabin top are painted light Gray
Bottom anti-fouling paint is Black
Gaff-rigged sloop configuration
Varnished Sitka spruce spars: mast, boom, gaff & jib club
All new (2017) Stainless steel wire standing rigging with bronze turnbuckle adjusters
All new (2017) Endura Braid Classic running rigging (sheets and halyards)
Lewmar Air-blocks for all halyards, running backstays & sheets
Masthead mounted Windex
2017 North Sails Mainsail
2017 North Sails Jib
Custom Double-Axle Triad Trailer with tongue extension for ramp launching
Side-mounted outboard motor bracket
PFD’s (6ea) Adult Universal
Electric / Automatic Bilge Pump
Manual Bilge Pump
Danforth anchor with Nylon rode.
P.O. Box 143
Brooklin, ME 04616