The iconic Nicholson 32 MKX One of the most successful designs of it's class. Encapsulated lead keel. Keel hung tiller steered rudder and non slip GRP decks! On the hard at Plymouth Yacht Haven being antifouled and available for viewing Call Mark on 01752 260086
GPR hull and deck.
GRP rudder supported on bronze gudgeon brackets
Yanmar 3GM30 27hp marine diesel engine - serial number E25927. Exhaust system comprises flexible exhaust hose, connected to a stern exhaust outlet via a Vetus muffler box/water lock.
Teleflex engine controls mounted in cockpit on the starboard side.Yanmar engine ignition panel in the cockpit companionway step/forward seat, includes rev counter, push-button start, key ignition and a warning buzzer and light system and engine stop lever next to the engine control.
Conventional 1” stainless steel shaft, sealed by a conventional packing gland with a remote greaser cup fitted in the port side cockpit locker. Stainless-steel shaft connected to the back of the reduction gearbox via a conventional coupling.
Three-bladed 16x9 bronze propeller secured to the stainless-steel shaft by a castellated nut and stainless-steel split pin. The stainless-steel shaft supported by a cutless bearing mounted in a bronze shaft log bolted to the back of the keel moulding.
12V electrical system charges the engine alternator and by a Guest Charge Pro 10 amp 230 V battery charger. Two 110Ah 12V batteries installed in a purpose-built timber box in the starboard side cockpit locker. The 12V system distributed via a fused switch panel over the companionway step and isolated by an adjacent battery selector switch.
230V shore power system with a connection point in the port side cockpit locker. The system is protected with an RCD circuit breaker fuse box mounted in the locker and includes battery charger and a kilowatt hour meter.
Electric 12v bilge pump (fitted 2019).
Keel stepped, gold anodised aluminium Sparlight mast and boom. Spinnaker pole.
Standing rig comprises 6 and 7 mm 1x19 stainless steel wire shrouds, with swaged terminals, tensioned by open bodied rigging screws locked by split pins. One main cap shroud per side with one set of spreaders; one forward lower stay per side; one aft lower stay per side; one backstay; one forestay with Harken MK IV 1 furling gear (fitted 2012)
New running rigging June 2019 (Main sheet, genoa and spinnaker halyards, topping lift)
Winches: (serviced 2019)
Two Lewmar 40 two speed genoa sheet winches;
Two Lewmar 8 single speed halyard winches mounted on the mast;
One Lewmar 6 single speed service winch mounted on the boom.
CQR anchor plus 8mm chain. and S-L 555 double action two speed windlassA secondary CQR kedge anchor.
Main (sail number 1947) vgc, spare main fair, furling genoa, storm sail. Other hanked on sails
5 berths in 2 cabins (forward cabin and main saloon)
Teak interior saloon.
Toilet and sink head compartment.
Stainless steel gas grill and two burners.
Raytheon ST60 Tridata depth/speed/log
Wind angle gauge
Close hauled wind indicator
Masthead wind indicator.
Seafarer Seavoice 550 VHF radio
Sestral Minor MK II steering compass
Hand navigation tools and charts
Two horseshoe lifebuoys with pushpit brackets.
Safety lanyard attachment points.
Ocean Safety 4-man canister type life raft (stowed on deck, requires service)
Radar reflector on mast.
Portable boarding ladder.