View the Virtual Tour: bit.ly/2DD6P58 Preliminary Listing - please call central listing agent for more details until full specs are available. New to the market. Equipped with the popular MAN Diesel 1050's. Don't miss out on this incredible fishing machine / elegant cruising yacht
OVERDRAFT is a very well maintained 50 Viking Convertible. She's equipped with recently overhauled MAN 1050s and less than 800hrs on a recently installed 15kw Phasor Marine generator. She also has New GARMIN Electronics, New VHFs, New Stereo, New Acrylic Bridge Curtains, New Salon TV, New Upholstered Salon Couches, New Salon Carpet! Recent bottom paint and plenty of care and attention to the little things, she is ready to go fishing or cruising at a moments notice. Comprehensively equipped, updated electronics, with a Tuna Tower. She is well worth your attention if you are looking to acquire a very clean and properly maintained 50 Viking convertible. Make a call today to arrange for your inspection of OVERDRAFT.
Please contact Daryl Brower at 252 259 0235
Tilleggsinformasjon, tilbehør og utstyr:
Flaggstat: United States
LOA: 50 ft 0 in
Bom: 16 ft 4 in
tørrvekt: 59000 lbs
Total Power: 2100 HP
Drev type: Direkte drev
Engine Power: 1050 HP
Engine Power: 1050 HP
The vessel is powered by a pair of MAN 1050 hp engines and cruises at 26 knots. The vessel is equipped with an Onan 15 KW generator. The vessel carries 850 gallons of diesel and 208 gallons of water.
She has three staterooms/two guest head layout that sleeps (6) comfortably.
Cockpit hatches accessed the lazarette, insulated fish box, live well and ice bins. Hatch pulls and gaskets seal out spray and wash down water into the lazarette.
The centerline helm provides 360-degree sightlines. Electronics were viewable from the helm. Twin ladder back helm seats. Port side and forward stowage below for rods and other tackle. To port forward was a bench seat with under storage.
A molded fiberglass sliding door leads to the salon. Immediately inside the doorway to starboard was the electrical distribution panel. Teak joinery fills the area with richness and detail. Air conditioning flows quietly from the valances for cooling and thorough distribution.
An L-shaped couch to port features stowage. The starboard forward L-shaped dinette seated 6 with and above flat screen television with surround sound throughout the salon.
The port side galley was U-shaped for maximum efficiency and features Corian countertops, under-counter Kitchen Aid refrigeration, a microwave/convection oven, an electric cook top, in-sink garbage disposal, a water tank gauge, Amtico teak holly sole, an electrical sub panel and stowage space for dinner and cookware, groceries and supplies. The two-stateroom two-head layout includes a master suite to starboard with a walk-around queen berth flanked with teak night stands and a credenza to port. A television was mounted above a second credenza. A generously proportioned cedar-lined hanging locker accommodates a sizeable wardrobe. The forward stateroom had a full berth with stowage and hanging locker capacity. The port stateroom had upper and lower berths along with a good amount of locker space. Each of the staterooms was fully carpeted, has stereo controls and speakers, overhead Halogen lighting throughout. The heads feature Amtico flooring, one-piece fiberglass shower stalls and medicine cabinets with mirror doors, exhaust fans, air conditioning and electric MSD with holding tank and overboard discharge capabilities. The engine room web-frame structural steel engine beds. These were mounted to dedicated transversals for vibration free engine and drive-train alignment. The hull was cored with end-grain balsa under the engines and the bottom hand-laid fiberglass laminates. Through-hull areas including struts, shaft logs and water intakes penetrate solid fiberglass. All overboard discharge through-hull fittings were manufactured of fiberglass to eliminate corrosion potential.
Deck and Hull
Modified V Planing Hull
White Gelcoat with boot top accent stripe
Engine room vents were molded into the hull and in good condition
Four (4) athwart ship reinforcement plywood bulkheads bonded to the hull
Athwartships reinforcement enhanced by structural bulkheads bonded or fastened to the hull with FRP (fiber reinforced plastic)
All tabbing sighted are sound with no cracks or separation of tabbing sighted in any compartments where accessible to view
No visual evidence of movement sighted in any bulkhead
Chain Locker (Drainage) located forward of the V-Berth bulkhead
Limber holes are of adequate size and clear where sighted
Solid stem, no cracks or separation sighted inside
Engine bed stringers were H Beams attached to FRP encased transverse frames
Longitudinal stringers ran fore and aft
No separation, cracks or splitting sighted in keel/bilge areas or when inspecting transducers
Additional stringers support in engine compartment and stringers are well glassed into hull
Transom with starboard side opening tuna door with serviceable hardware
No delamination found with percussion hammer
Molded FRP cockpit
Nonskid areas were painted with white gelcoat
Deck was not spongy or soft and was solid under foot
Center fish box with two hatches with pull handles
Lazarette deck hatch with pull handles
Cockpit corner drains
Port refrigerated box
Bait prep station
Center access to engine compartment
Bridge and Tower
Varnished teak helm pod
Single lever controls
Raised console electronics box
Port helm electrical control switches
Helm radio box
Engine gauges were in the helm console
Teak ladder back helm chairs
Forward helm console bench seat and port inward facing seating
Drip dry foam in flybridge cushions
Cushions in good condition
Three (3) Sided enclosure with track to track mounting with opening panels’ front, and sides
Viking fiberglass hardtop
Aluminum Frame with Composite FRP top
Supports Radar, Spotlight and Antennas
Flush mounted quartz lights mounted into hardtop
Forward bridge section to allow visibility to bow when running
Aluminum structure with an upper steering platform
Canvas buggy top
Molded FRP helm console with cover
The entry to the salon was Amtico sole flooring, allowing one to enter the salon without soiling the carpet. Access to the electrical panel and audio visual equipment was accessible for easy breaker checks or power switchovers. The teak sea rail along the cabinetry panel doubles as a handrail. A built in forward bulkhead flat screen LCD TV and offers viewing from the settee. Additional overhead lights were switched separately and all the lights are on dimmers.
Starboard side forward L shaped dinette with teak table with a large settee
Under seat storage
Port side forward L with under storage but up to galley countertop
Island bar stools
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.